We offer same-day service, and if you do decide to get your appliance fixed, we waive our diagnosis fee!
Also, our work is 100% guaranteed! We fix right the first time and give you 90 days warranty.
We are committed to helping you get your stove or oven fixed for the long run. 
Our team is highly trained and will give you the best diagnosing in order for you to make a well informed decision.

Then look no further as we are the leading appliance repair company in the city. Our professional and dedicated technicians have been serving our customers for many years. In fact, our quality workmanship and exceptional customer service have made us one best appliance repair NYC companies. Our expert technicians offer full service of repairing all brands of appliances. 

1. Disconnect the machine from the network and try to drain the water from the pump filter (below, right). To do this, take a flat container, slightly lift the front edge of the machine, substitute container and slowly unscrew the filter before the water will pour. After filling the tank, screw the filter back, drain the water and repeat the steps until all the water drain.
2. Check the filter and drain the system for blockage. Check serviceability of the pump.
3. Inspect the other elements of the washing machine.

If after the water set machine does not rotate, it is possible to wear the motor brushes. If you rotate, it is possible to faulty heating element, it just has to be involved in some time after entering the water and if it does not, the electronics can osttanovit washing process.

There may be two reasons:
1. If the water is clear, then skip the intake valve (needs to be replaced).
2. If the water is cloudy, it is not properly connected the drain hose and then the water from the sink in part goes into the machine (connect the drain hose correctly).

Engine Fault. Sometimes the error is corrected reset, but tend to either replacement of the motor brushes, or its repair or flashing the module.

Often, when the electronic washing machine detects a fault more water set the stage, then the command is given to stop the wash and drain the water. The first thing to check the heater, and possibly the engine, and then go through the circuit to the electronic module.

First check whether the correct set the machine on the floor. Do not tilt, if not displaced during washing. If set rigidly, the strong vibration can also be seen from the wear of shock absorbers or tank bearing.

Here there is a clear deterioration of parts. Either the tab on the door or lock hatch inside the machine housing

This imbalance of laundry, the machine can not expand it evenly to reach the spin cycle. This often happens when one wears a big thing. Try to report to the tank a few smaller things to the machine was able to balance the laundry.